Finish the wall.

Two colors, both yours to choose.

Screwless plates for the outlets and switches already in your wall.

Two plates split by a diagonal: a duplex outlet above, a toggle switch below. The base sits on the wall with four magnets and the cover seats into it, leaving a 2 millimetre frame of base showing.

Two parts, one minute.

No visible screws. No wiring. One screwdriver.

  1. 01

    Base

    A slim base takes the place of your old plate and screws onto the same switch or outlet. Nothing electrical changes and nothing is replaced.

  2. 02

    Cover

    The cover sits on the base, held by magnets. No visible screws on the front.

  3. 03

    Change

    When the wall changes color, order covers. Off and on with a fingernail.

Neutrals Sit with the room

Cotton Peanut Fossil Charcoal

Brights Or against it

Candy Mint Butter Ice

Change the color. Keep the base.

The base stays on the wall. A new color is just a new face – order covers, click them on, no tools and no reinstall.

Shop covers

Measured, then stated.

Every figure here is measured on the manufactured part.

Base
4.72 × 2.76 × 0.20 in120 × 70 × 5 mm
Cover
4.57 × 2.60 × 0.06 in116 × 66 × 1.5 mm
Base
4.72 × 4.72 × 0.20 in120 × 120 × 5 mm
Cover
4.57 × 4.57 × 0.06 in116 × 116 × 1.5 mm
Base
4.72 × 6.69 × 0.20 in120 × 170 × 5 mm
Cover
4.57 × 6.54 × 0.06 in116 × 166 × 1.5 mm
Base
4.72 × 8.66 × 0.20 in120 × 220 × 5 mm
Cover
4.57 × 8.50 × 0.06 in116 × 216 × 1.5 mm
Frame
0.08 in (2 mm) uniform, on all four sides
Seat
Cover sits flush with the base rim
Fits
Duplex outlets, toggle switches, Decora devices
Finish
Matte, eight colors on each part
Install
One screwdriver, about a minute

Before you order.

Will it fit my outlet?

It fits the standard devices already in your wall: Decora-style switches, dimmers and rockers, toggle switches, and duplex outlets.

Do I need an electrician?

No. The base replaces your existing plate and screws onto the same device. No wiring is touched and the outlet works as before.

Will I have to touch up the paint?

The base is 6mm taller than a standard plate, so it covers the old outline above and below. It is the same width, so a horizontal paint line, if you have one, may still show.

Can I mix colors between the base and the cover?

Yes. Any of the eight finishes on either part.

I rent. Can I use these?

Yes. It is a plate swap. Keep your original plate and put it back when you leave.